[*] PAP2

[Dan & Michele]

Thanks for the note Kevin ... if you can pass along any references that 
would be great ...

I've heard that also, that if you do the reset with linksys branding, it 
will go back to lock state.  I've never heard of the reset with the 
sipura firmware though ... never came across that yet ...

Dan.

Kevin D Scott wrote:
> In my reading, after unlocking the PAP2 with the Sipura firmware, it is
> noted that you should factory reset with the Sipura firmware on the device
> before putting the Linksys branding back in.
>
> Some users were reporting that if you do a factory reset with the Linksys
> branding, without doing the reset with the Sipura firmware, that the Linksys
> will revert back to the Vonage locked state,
>
> But with the new firmware that fixes the hole, allowing the firmware change
> in the first place.
>
> This could just be rumor, but I thought I would throw it out there, as not
> all of the "How-To" guides mention it.
>
>
> Kevin
>
> _______________________________________________
> Asterisk mailing list
> Asterisk at muug.mb.ca
> http://www.muug.mb.ca/mailman/listinfo/asterisk
>
>
>